Re: Okuma VMC
hy rishikesh
how to check condtionons to satisy this output QX0534.1
try "IF [ VORD [ 0221 ] EQ 1 ] "
how to search these addresses related to Door under I/O monitor as Label to search is unclear
look not only at "label" but also at "comment"; you have to check each item, since is not possible to search in all fields at once ( at least i could not do it )
if you get tired of this method, then you may check all displayed items at once, by opening/closing the door from the panel, and looking at the screen, so to find which item is changing color : so you have to toogle the signal, and look at the item that is flasing on screen; this method allows to check 15-20 items at once
searching may take a while ... be patient, search only 5minutes each day, etc try asking your okuma dealer about those, maybe you are lucky
meaning and usage of Change mode PLC
enabling/disabling acces to the possibility of forcing signals and/or using a mask
... if it is disabled, then you can only check the values
... if it is enabled, then you can also change the values, and use a mask to force permanent signal states ( for example to have a faulty equipment to output an "ok" signal, so you could continue machining until service team will arrive )
in most cases, it is enabled when new hardware is installed, or when cnc is delivered, or during remote service sessions, etc
i have also seen those areas(like a highlighted matrix), but so far i have never needed to change something there
i guess that is like a map that shares same info like the management data card
Front door lock &operator door close were not coming together hence output for front door close was not getting ON, we could resolve the issue
please, if i may, how did you fixed it ?
i have seen big doors erroring out during machining ... too heavy for the small locks / kindly
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg