wishing dolphin had adaptive or high efficiency milling!
i am trying to learn anything on fusion 360 and smartcam to get some better open pocket tool paths.
they seem to be very good at hiding the single task of taking 3 lines and getting a profile to cut out
after i think about 10 years of using dolphin i can do miracles with it in tool path!
some of this is doing a lot of custom long hand cam but it is very fast to do and works.
i am about ready to spend 2000$ on another cam that i would prefer to give to dolphin if they could do this stuff....
shizuoka an-s knee mill=kflop/kanalog running nema 34 dc brushed servos
cincinnati sabre 750=kflop/kanalog building now with ac brushless servos