Hi everyone.
I’ve been on the ’How I fixed my Chinese TB6560 controller’ thread as I purchased a machine with this board in it. The board was toast so I fitted the newest version.
So I have a new problem now. Everything is plugged in, my Y and Z axis are moving great. My X axis is being weird. My X steppers are mostly running in opposite directions to each other. I say mostly because they occasionally run in the same direction. They also swap what direction they are going in, even when just pressing the same direction button over and over???
I have the TB6560AHQ board, running Mach3, have KL23H286-20-8B steppers Wired in series and powered by a 24v, 6.5amp transformer.
I know that in the future I need to wire the steppers in parallel and get a larger transformer but for the time being I just want to get my table running.
Any extra help would be much appreciated.