[kesseli]

Hello all machinist

I have problem with Direct drawing dimension programming.

My lathe does not recognize if i programming roundings to corners.

Example if i write command:
z-10x40R2:
z-20:

Lathe only turns z-10x40 and then moves z-20, but doesnt not make 2mm rounding to corner.

I know that some other fanucs needs , symbol before R. i tried it, but that didn`t works.

Ideas what is wrong?

[mbservice]

Hiya
The option was probably not required at time of original purchase and was not activated in the parameters

[kesseli]

Hi Mbservice!

in operation manual reads: including all option functions. So that should be working?

I noticed one thing, when I put comma in front of the R symbol, it does not go to the same command. If i try to test drive it makes alarm.

[mbservice]

Hi Kesseli
That looks like the Fanuc manual so would show it but does not mean it was activated by the manufacturer