I want to make a friction drive for tracking a telescope for astrophotography work but lack the mechanical engineering knowledge to size the components appropriately. The drive is simply one smooth disc of material pressed against another - basically like two cogs, but without the teeth.

Coefficients of static friction for steel appear to vary, but a figure of 0.5 seems like a reasonable starting point.

I understand that the friction between the wheels is purely proportional to the force pushing the two surfaces together (not the contact area); so if two steel wheels were pushed together with 5N of force then the drive should handle 5N x 0.5=2.5N of force at the contact point, before losing traction.

That's the theory, but how would you go about actually choosing the diameter and thickness of the discs in your friction drive? Clearly below a certain thickness there's a risk the discs may bend/warp/deform as a result of the force applied to push them together, but there's also no point in making the discs too large.

There are commercial friction drive telescope mounts - such as the Mesu. One of their models (claimed to carry ~130kg) achieves a 3000:1 reduction with the use of three stages:

2mm diameter input to 40mm diameter output (20:1)
2mm diameter input to 50mm diameter output (25:1)
50mm diameter input to 300mm diameter output ( 6:1)

There's a diagram on the second page of this review: http://www.astro-imaging.com/Equipme...unt_Engels.pdf

For my application, I already have a 100:1 harmonic drive, and I'm looking to add a 10:1 friction drive stage, for a mount capable of carrying a telescope around 30kg.

The telescopes are usually balanced; such that you just need enough torque to get the scope moving. A previous test of my scope indicated something around 5Nm would be required. I put together a really hacky friction drive using MDF discs which slipped at around 2.7Nm, so it gives me hope this is feasible.

I'm limited to a diameter of around 160mm with my little metal lathe; which would point to a 16mm input driving a 160mm output - but would that be suitable? How thick should I make the discs? How do I calculate what would be suitable in mild steel?