Hi All- I'm designing a new mill and want to use UCCNC and the AXBB-E. I use UCCNC so all good there. Is the AXBB-E all that's needed? I will have XYZ and a slave on X and a slave on Z so need 5 axes. UCCNC has 6 and AXBB-E has 6 I believe. Any suggestions or experience with this? or better options?
Also I'm looking at the steppers with integrated drivers any experience with these out there?
https://cncdrive.com/AXBB.html
https://www.omc-stepperonline.com/is...-12-38vdc.html
would like it to be a bit higher voltage and lower inductance though...
cheers Peter