Hi all,
been using the RZNC 501 controllers for 3 -4 years.
Every time i start the new cutting process, the system will automatically goes to SPD GRAD 7, even though during the processing menu, I set it to SPD GRAD 1, it will still runs at SPD GRAD 7 during the cutting process.
Another question i have: I am using ArtCam. But i cannot seems to set the speed of the milling process using the RZNC controller.
Example i set 5000rpm on my ARTCAM, but my RZNC 501 controller only seems to runs at the speed set on the RZNC controller. I can only manually set the speed using the RZNC controller during the milling process.
Thanks, hope you guys can help me in these issues.
Ivan