586,108 active members*
3,115 visitors online*
Register for free
Login

Thread: canned cycles on 16t?

Results 1 to 4 of 4
  1. 07-08-2007, 06:34 AM #1
    DocHod
    DocHod is offline Registered
    Join Date
    Jan 2005
    Posts
    49

    canned cycles on 16t?

    Hi all I have a question about a 16t controller that I use , when the capII was installed in the machine to use the F.A.P.T. and years later I went to use canned cycles for drilling the controller would not acknowledge the drilling cycle , is this a parameter problem or not? any help I would be grateful thanks.
    Reply With Quote Reply With Quote
  2. 07-08-2007, 06:54 AM #2
    M-man
    M-man is offline Registered
    Join Date
    May 2006
    Posts
    265
    Ive got 18iT with Fapt2 and I can still use all canned cycles.
    Reply With Quote Reply With Quote
  3. 07-08-2007, 09:48 PM #3
    bob1371
    bob1371 is offline Registered
    Send a message via Yahoo to bob1371
    Join Date
    Nov 2003
    Posts
    98
    Hope this helps.
    Parameter 9929 Bit3=1 "CANNED CYCLES FOR DRILLING"
    Parameter 9944 Bit7=1 "TYPE II CANNED CYCLES"


    Bob
    Reply With Quote Reply With Quote
  4. 07-09-2007, 01:58 AM #4
    DocHod
    DocHod is offline Registered
    Join Date
    Jan 2005
    Posts
    49
    Thanks I'll check the parameter Monday morning.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. canned lathe cycles
    By PETE1968 in forum Mastercam
    Replies: 3
    Last Post: 05-27-2007, 12:44 PM
  2. Help w/ Fanuc 6T Canned Cycles!
    By andys2006 in forum G-Code Programing
    Replies: 1
    Last Post: 04-17-2007, 03:15 AM
  3. G90/G91 in canned cycles
    By alfalfa in forum CamSoft Products
    Replies: 18
    Last Post: 02-25-2007, 12:20 PM
  4. canned cycles on Haas
    By GITRDUN in forum Haas Mills
    Replies: 3
    Last Post: 09-21-2006, 01:58 PM
  5. Incremental Canned Cycles?
    By Rekd in forum Haas Mills
    Replies: 16
    Last Post: 11-15-2003, 07:23 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules