Hi, I purchased a Mazak QT10N lathe recently. However, all the parameter were gone now. Is there anyone could advise me how to reinstall the parameter back to the system?
ps: I already have the OP parameter. Thank you.
Don
Hi, I purchased a Mazak QT10N lathe recently. However, all the parameter were gone now. Is there anyone could advise me how to reinstall the parameter back to the system?
ps: I already have the OP parameter. Thank you.
Don
through Data I/O
The OP parameters require a parity bit added when you enter them, e.g. if the parameter is 10010010 the the parity is added so 100100103 (3 bits = 1).
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thank you for the above 2 gentlemen.
I will try that out.
Thank you!!
Don
Hello everyone.
I have also problem with Mazak QT 10N with mazatrol T2 control unit.
I have lost parameters because I have problem with battery. I have done something but it is not good enough.
It will be grate if someone can send me a copy with parameter.
Hello Don.
I have so that you have OP parameter for mazatrol T2 and that is what I need.
I am asking you for favor to send me a copy of it.
My email is [email protected].