My spindle on my kx1 3501 is acting goofy.
Slows and stops then starts again. Any ideas?
I contacted Little Machine Shop and they told me to contact China because I bought it from Little Machine Shop ten years ago. I can't get a response from China its been almost 5 months! Thanks.
Thread: Spindle pulses?
Results 1 to 1 of 1
-
04-17-2020, 06:33 PM #1
Registered
- Join Date
- Sep 2009
- Posts
- 14
Spindle pulses?
Reply With QuoteSimilar Threads
-
Zen spindle only runs in pulses
By flaplante in forum Zen ToolworksReplies: 1Last Post: 07-18-2017, 03:40 PM -
slow pulses
By sambuls in forum LinuxCNC (formerly EMC2)Replies: 2Last Post: 03-17-2010, 10:11 PM -
Max pulses and IPM
By margni74 in forum LinuxCNC (formerly EMC2)Replies: 7Last Post: 12-05-2008, 06:11 PM -
Multiple pulses for spindle encoder - how to install?
By LeonM in forum Mach Software (ArtSoft software)Replies: 2Last Post: 06-22-2008, 01:28 AM
Tags for this Thread
Posting Permissions
