Our Journeyman 325 with allen bradley 9 control intermittently drops the tool during machining cycle
we do not know if we have type 1 2 or 3 spindel
Our Journeyman 325 with allen bradley 9 control intermittently drops the tool during machining cycle
we do not know if we have type 1 2 or 3 spindel
Look up in the taper. Rev 3 has collet with 6 balls and 6mm Allen screw in middle. Rev 2 has a collet with 3 balls and a knock-out button in center past the taper. Rev 1 has 6 pins, 3 each on two different levels past the taper. We rebuild them all. [email protected]
Thank you we will check it out
the was metal chips up inside the collet so we are hoping now its cleaned the tool will not pop out now
Good luck. Shoot me an email if you need anything else!
[email protected]