[artracing]

Thanks , But i don't think this is my case
If you run my file you will see.
its 3.5" block. I'm cutting .25" deep.
It only goes .2 "
You can see it in the model and I ran it on my machine.

[The Engine Guy]

Thanks , But i don't think this is my case
If you run my file you will see.
its 3.5" block. I'm cutting .25" deep.
It only goes .2 "
You can see it in the model and I ran it on my machine.

I can`t run your file, I only have V31 demo so it won`t open your file as it is a later version you have.
I have tried to replicate your issue in V31 but apart from what I posted earlier I have nothing else for now.
I will try to replicate it in my V28
Regards
Rob

[artracing]

Yes, I'm using 32.

Where is BC techs here. I think this is a bug. But then again , i just might be doing something right.

[BurrMan]

Yes, I'm using 32.

Where is BC techs here. I think this is a bug. But then again , i just might be doing something right.

I could make a video, or just tell you here.... (If that picture is it)

[BurrMan]

Fancy Video... Watch out for the bad audio. Havnt used a Mic in awhile. Kindof blown out..

https://youtu.be/n9l2zkUWxpQ

[artracing]

Fancy Video... Watch out for the bad audio. Havnt used a Mic in awhile. Kindof blown out..

https://youtu.be/n9l2zkUWxpQ

Thank you for that. It was very helpful. It gave me a solution to my problem but appears there are issues that are now bugs.
I removed the allowance and it worked.

1, That says I can't leave a finish allowance?
2. Change the cut depth to .100 will only allow .200 cuts but leaves .050 uncut
3. GO back ,125 depth and it cuts the full .25
4. Set allowance to .0001 and it wont do the second cut.
5. The only way it cuts the full .250 , the depth must be set a even multiple, or it won't make the last cut.

This sounds like a bug to me.