[Clive S]

PP din socket for tool setter.

I have a tool setter non Tormach but looks the same mine does not have a led only to switches one for the tool trip and the other NC for the over travel fault.

I am looking for the connections to this DIN socket for the two switches. I believe pin 1 is 5v dc - pin 4 is common - pin 2 not used - pin5 input - pin 3 is 12v dc

[cbyrd]

This is the schematic for the 1100m

[Clive S]

Thanks for the info. My machine only has one Din socket. I would have thought that the Tormach setter would have a safety second switch in case the first one fails for some reason

The same socket is used for different probes

So I am looking for the correct pins on the din socket to put the switch across

[BGHansen]

Thanks for the info. My machine only has one Din socket. I would have thought that the Tormach setter would have a safety second switch in case the first one fails for some reason

The same socket is used for different probes

So I am looking for the correct pins on the din socket to put the switch across

Millfast Products advertises adapters that allows two devices to be installed. Depending on the model, they have one for 2 NO switches and a NO/NC version.

[Clive S]

Thanks for the info. My machine only has one Din socket. I would have thought that the Tormach setter would have a safety second switch in case the first one fails for some reason

The same socket is used for different probes

So I am looking for the correct pins on the din socket to put the switch across

With further investigation the pins to use are pin 4 and pin 5 looking at the front I have use NC contacts. So this is now solved thanks to all for the feedback.