Hi Okuma guys,
I need your advise about OSP-5000M DNC-B technical book to solve W30 communication error.
If an one have MCV-A electrical wiring diagram, I need to use it too.
Send me at [email protected]
Best Regards,
Inuc
Results 1 to 1 of 1
-
05-15-2020, 10:01 AM #1
Registered
- Join Date
- Mar 2008
- Posts
- 34
Okuma- MCV-A with OSP-5000M with DNC-B error W30
Reply With QuoteSimilar Threads
-
okuma osp 5000 bus error and cycle error led on
By astral in forum OkumaReplies: 10Last Post: 08-23-2022, 05:37 PM -
okuma osp 5000m with dynapath delta 2000m controller
By tharris1992 in forum Community Club HouseReplies: 5Last Post: 08-12-2013, 08:44 PM -
OKUMA OSP 5000M SVPII-0 BOARD
By keyancnc in forum OkumaReplies: 0Last Post: 12-26-2011, 05:03 PM -
OKUMA HORIZONTAL W/ FANUC OSP 5000M
By TOOLSHOP in forum OkumaReplies: 2Last Post: 06-03-2009, 06:56 AM -
Horiz. Mach . Okuma Mc 5h , Osp 5000m , 1981-82
By markodacosta@ne in forum CNC (Mill / Lathe) Control Software (NC)Replies: 1Last Post: 10-05-2008, 04:05 AM
Tags for this Thread
Posting Permissions
