I'm super happy with my 770 , so happy that I've been telling everyone I know exactly how happy i am .
Because of that word has gotten around that I have a cnc mill and this morning I was offered some work .
It's a short term job that pays pretty decent , but would tie up my 770 for 4-5 weeks and I don't want to put my own work that far behind
The pay is good enough that I could buy a basic 440 , run The job and pay for the machine while still putting a nice chunk of change in my pocket.
The parts are rather simple , not super high accuracy and only need a single tool to make .
So ... to make it work and keep as much cash in my pocket as possible I would want to avoid buying a stand .
I currently have two possible solutions , one is bolting it down on top of my snap on tool cabinet that has a 1.5 inch thick maple top .
The other is mounting it onto the cast iron table saw I use for a work bench .
Thoughts ?