Hi All,
*I'm using PowerMill 2020 on a Haas 5 axis trunnion type of machine.
*I'm wireframe swarf cutting the entire periphery of a part with a constant
5 degree draft.
*In the simulation it all looks good.
When executing on the machine*it leads in,machines around until reaching the point of passing C zero
where it rotates C360.0 back to the same position it was at , then continues the path and leads off of the part.
During this repostioning it does not lift z or reorient the A/C axis positions to prevent gouging.
Is this a setting in the post , the PM software, or a machine setting?