Good day to you all, I am having problems with the X axis Wrapping on a job.
I want to cut a 60.0 degrees slot x0.250 deep on the OD of a 3.500 dia bar.
I have calculated the length of the arc to be 1.832" at the 3.5 dia and drawn the curve over the part and then created this as a side feature.
I thought I could simply use the "Wrap Feature Around X Axis" tick box to generate the feature.
The angle cut has been measured by inspection and is showing 54.0 Degrees.
I then proceeded to re calculate the arc length at the 3.0 dia and created a new curve/feature at -0.249 with a 0.001 depth of cut. This time the included angle measured 53.0 deg.
Any thoughts on what I am doing wrong?
Many thanks.