Been trying to get a license activated and can not get on the website or support website since yesterday. Did a tracert and it ended up not at the correct site and timed out??? Never issues in the past with my account??
Been trying to get a license activated and can not get on the website or support website since yesterday. Did a tracert and it ended up not at the correct site and timed out??? Never issues in the past with my account??
Retired Master Electrician, HVAC/R Commercial. FLA Saturn 2 4x4 CNC Router Mach4 Kimber 1911 45ACP
I didn't try logging in, but the website loads just fine.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I am unable to access the website with either MediaCom cable or Verizon Wireless, oops just got on with my cell phone or Verizon network. Its still timing out on the cable connection, before I could not bring up on either??
Retired Master Electrician, HVAC/R Commercial. FLA Saturn 2 4x4 CNC Router Mach4 Kimber 1911 45ACP
Tah da... took my Verizon cell phone to the shop and tried what I tried yesterday made it a Hotspot and connected my shop computer thru it. Ding ding, worked like a champ now so I got my Mach4 licensed on the new NUC computer, which now does all the shop stuff. The old one was so s l o w, this is not a speed demon but it works without crashing and runs all my CNC. Thanks Gerry, I suspect tomorrow my cable will be fine connecting to the Mach site. This $hit used to drive me crazy when I was doing website design.
Retired Master Electrician, HVAC/R Commercial. FLA Saturn 2 4x4 CNC Router Mach4 Kimber 1911 45ACP