Hi all.
I'm in the process of designing a CNC router. The Table will be 4m x 1.8m approx..
Has anyone used the THK LM GSR-R combined linear rail with integral gear rack?
If so any feedback?
Cheers GV
Hi all.
I'm in the process of designing a CNC router. The Table will be 4m x 1.8m approx..
Has anyone used the THK LM GSR-R combined linear rail with integral gear rack?
If so any feedback?
Cheers GV
Nope haven’t done that. However such a rail system should reduce alignment errors.
I'm going to assume that it's far more expensive than most DIYers would be willing to spend. But It's probably a very good system.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Ok so got in touch with the distributor today.
Wont work.
Too expensive about AU$6000 for 10Lm
Also they have to be fixed flat, I want to mount them on the side of the machine so another linear rail would be needed to stop I flexing off.