2nd clearing pass not aligning with the first pass...Its not the machine! Please Help!
2nd clearing pass not aligning with the first pass...Its not the machine! Please Help!
Have you verified that by looking at the G code and finding the misalignment there?2nd clearing pass not aligning with the first pass...Its not the machine! Please Help!
If it looks correct in the preview then it isn't a code issue. Look elsewhere.
I recently had a similar problem on multi-pass clearing paths in which had errant Z-axis step-downs.
To make a very long story short - the issue was resolved by a firmware update. Along the way, I used a 3rd party simulator to rule out g-code issues, aligned the machine, and repeatedly ran test toolpath cases using two different jobs to rule out speed/feed as the source of the mischief.