[okuma1984]

...is your machine chucking CycleStart Interlock set for clamping on OD or ID? or maybe the two M codes on the same line needs changed M3M41 maybe a problem

so i tried without the M41
but nothing again. i don't know about the cycle start interlock? how do we check that?

where would this be
i don't have the key for it but on my other okuma this is always in the middle position

[machinehop5]

so i tried without the M41
but nothing again. i don't know about the cycle start interlock? how do we check that?

quick way to test if Workpiece clamping is the cause....just try running the program with nothing in the chuck with jaws open using foot switch...aka I.D. clamped

It looks like a parameter setting for "Workpiece clamped" Interlock. Not sure if this is your manual but, look in your manual for the Parameter
Okuma OSP7000L Model U LFS15-2SP Instruction Manual pdf - CNC Manual

Attachment 447038

[deadlykitten]

hy machinehop that is a good idea, to help him run the trials faster ... but i'm afraid that there is always needed something in the chuck, regardless of od/id clamping status, because there are safeties, that involve proximity senzors and pressure senzors

in order to run " hollow ", is needed to use the " grasp interlock cancel " spec, but this special function is costly, and was not designed for testing programs

the simpler way arround is to lock the machine, by pressing [ I-L ] + another button, like shown in attached, in order to put the machine in simulation mode; like this, real machine won't move, but display will work, even if there is nothing inside the chuck : this helps, for example, to test a future program, even if current machine setup is running a different program; sorry for all these explanations, i mostly wrote them for okuma1984 / kindly

[okuma1984]

hy machinehop that is a good idea, to help him run the trials faster ... but i'm afraid that there is always needed something in the chuck, regardless of od/id clmaping status, because there are safeties, that involve proximity senzors and pressure senzors

in order to run " hollow ", is needed to use the " grasp interlock cancel " spec, but this special function is costly, and was not designed for testing programs

the simpler way arround is to lock the machine, by pressing [ I-L ] + another button, like shown in attached, in order to put the machine in simulation mode; like this, real machine won't move, but display will work, even if there is nothing inside the chuck : this helps, for example, to test a future program, even if current machine setup is running a different program; sorry for all these explanations, i mostly wrote them for okuma1984 / kindly

don't worry. you're addressing a professional machine operator here. i have a very extensive knowledge of G code programming and fanuc. i have pushed buttons for 10 years!!!!!
lol my only problem is with the mechanics of this machine or trying to find out what's wrong with it. i will give it a shot with the modified program. it could very well be a G13

[deadlykitten]

ok, just give it a go

facing

G50S500
G13
G0X22.0Z22.0
T0202
G96S200M3M41
G0X3.0Z0.05
G1X0.0F0.005G95
Z0.1
G0X22.0Z22.0
M30(orM2)

only rpm

G50S500
G0X22.0Z22.0
T0202
G97S180M3M41
M30(orM2)

i hope that mechanics are fine do you have 2 turrets ? 2 spindles ? automatic doors ?

[qwret]

Hi, my friend recommend me a service which help with programming tasks.
See for yourself! https://domyhomeworkfor.me/philosophy-homework-help