Miyano mill
Changed over to inches par 1001 and 0000 but the resolution on the DRO showes twice what I’m actually moving. If this was the cross feed on my lathe I’d be perfect!
What did I miss?
Sent from my iPhone using Tapatalk
Miyano mill
Changed over to inches par 1001 and 0000 but the resolution on the DRO showes twice what I’m actually moving. If this was the cross feed on my lathe I’d be perfect!
What did I miss?
Sent from my iPhone using Tapatalk
Change 1001 back to it's original settings. ONLY change parameter 0000. When you change parameter 1001 you tell the controller that you have either a metric or inch ball screw. A ton of parameters are based on this setting. Parameter 0000 sets the part program to run in metric or inch. Better yet, use G20 and G21 in the program to switch between inch and metric
Got it, works, much appreciated!
Sent from my iPhone using Tapatalk
Well it did change the relative position but not the machine or absolute but is traveling in inches correctly.
Sent from my iPhone using Tapatalk
Sorry relative and absolute are in inches the machine is not.
Sent from my iPhone using Tapatalk