Any body know how to activate SSV on there TL-1? I have entered values for setting numbers 165 and 166 (200 and 20 respectively) then MDI'd a M38 and turned spindle on but only get a non varying RPM. Will it work on canned cycles?, MDI mode?, only in programs?
Results 1 to 6 of 6
-
07-21-2007, 10:38 PM #1
Registered
- Join Date
- Feb 2005
- Posts
- 38
TL-1 SSV (spindle speed variation)
-
07-21-2007, 11:29 PM #2
Gold Member
- Join Date
- Jul 2005
- Posts
- 12177
I know it works in a program and in the G71/72/70 cycles. I will have to check about MDI.
An open mind is a virtue...so long as all the common sense has not leaked out.
-
07-22-2007, 12:21 AM #3
Gold Member
- Join Date
- Jul 2005
- Posts
- 12177
Works on mine. Turn spindle on first then M38.
An open mind is a virtue...so long as all the common sense has not leaked out.
-
07-23-2007, 02:44 PM #4
Registered
- Join Date
- Jul 2005
- Posts
- 181
Work on mine too and very usefull on long overhang boring bar boring.
-
07-24-2007, 07:42 AM #5
Registered
- Join Date
- Feb 2005
- Posts
- 38
Ahhh... Turn spindle on first then M38. It works.....how cool. FWIW you can run a "Automatic mode" canned cycle after turning on SSV. However you must turn it back on after each canned cycle is run.... but you guys new that already.
Thanks to all who replied,
Don
-
07-25-2007, 05:48 AM #6
Gold Member
- Join Date
- Jul 2005
- Posts
- 12177
I have not used SSV very much mostly because the spindle drive hovers around the 100% mark with the constant speed change. Maybe I am too conservative but I don't like running things near 100%. But as Wiseco says it does work well for long booring bars.
An open mind is a virtue...so long as all the common sense has not leaked out.
Reply With QuoteSimilar Threads
-
How to modify HPLG file to compensate for the speed variation of my laser engraver ?
By g1zmo in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 05-10-2007, 04:16 AM -
Spindle Speed
By kentavv in forum Charter Oak Automation Support ForumReplies: 4Last Post: 01-28-2007, 05:40 AM -
spindle speed
By Mike Boarman in forum Machines running Mach SoftwareReplies: 0Last Post: 11-28-2006, 04:37 AM -
BPSeriesI / Centroid control- Spindle speed all out of whack with speed dial?
By peter.blais in forum Bridgeport / Hardinge MillsReplies: 9Last Post: 08-08-2006, 09:29 AM -
Low speed spindle?
By cbass in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 02-25-2005, 10:38 AM
Posting Permissions
