Hello, everyone.

I hope everyone is in good health and being safe out there


Can some one look over my UCCNC Setting for Stepper motor on AXIS-X,-Y,-Z

I hive upgrade my 6040Z from the small stepper motor is had, To LONGSMotor & Stepper Driver.
So the Stepper Motor i got:

Nema 23, 425oz, 3A, 1.8deg/step 23HS9404B dual shaft.

Stepper motor driver:
DM542A, PEAK 4.2A, 128 micsteps

Power Supply:
3X- MEAN WELL Single Output Switchable Power Supply, 349.2W 36V 9.7A - LRS-350-36

The DIP switch setting on stepper drive are below:

SW1 SW2 SW3 SW4 Peak/RMS
Off ON OFF OFF 3.32 / 2.36

SW5 SW6 SW7 SW8 Pulse/rev
OFF ON ON OFF 2000

The previous setting factory default that came fron LONGS where:
Peak/RMS Pulse/rev 2.84 / 2.03 1600
With these setting the motor where moving rough, Instead of smooth.

The picture's below showing AXIS setting from uccnc, Want to make sure that the motor's are
tuuned correctly.

Thanks