I am looking to sell my tormach series 3 that I purchased new in october of 2017.

I used it for 1 year in my garage but largely stopped using it as of late 2018. (purchased a full sized vmc)

I have 30+ Tormach brand tts holders to go with the machine. 22 ER20 holders, 7 set screw endmill holders, and 6 floating tap holders.

The machine is mechanically sound with fairly low hours. Backlash is the same as it was when I bought it new and I haven't needed to adjust the gibs. I don't know the exact number of hours on the machine but I would estimate it to be 100 to 200 hours spindle time total.

There are some visual defects. There is some minor surface rust on the table as well as on the spindle nose. There are lots of little scratches in the encloser from where I scraped out chips. There is also some paint flaking in some areas.

I am located in Romeo, Michigan. Local pickup only, I have a forklift and can load on a trailer. The machine is currently under power.

Asking 10k OBO.