Hi all ,
i am running into some problems with my Victor V26 II with fanuc 18T controls .
i bought this machine recently and never used a lathe that has a part catcher installed before .
now i have a part that i need to produce where i could use the part catcher .
i want to catch the part when i cut it off the stock material so when the spindle is still turning .
however when i command the part catcher to come out the spindle stops and refuses to start until i move my part catcher back in .
is there any way i can make my spindle and my part catcher work at the same time ?
thanks ,
Aäron