Re: Need helpful ideas on how to reduce burrs on cross hikes with internal thread
I don't really understand why a tap could not be run through the part by hand as part of the debur operation. It might make sense to cross drill then thread. Maybe thread mill rather than single point on a turning machine.
But overall it sounds like an order of operation problem. Normally when I set up a job I plan the cuts to eliminate any burs during the process because I really hate deburring. Any final debur operation required is done in a vibratory deburring operation.
Without seeing the part it would be difficult to offer any meaningful advice.
Jim Dawson
Sandy, Oregon, USA