Where can I go to start learning about LinuxCNC? I have been around cnc and plc stuff for 10 years, but have never looked into this. Any help pointing a newbie on the right direction would be great.
Where can I go to start learning about LinuxCNC? I have been around cnc and plc stuff for 10 years, but have never looked into this. Any help pointing a newbie on the right direction would be great.
find an old x86 putor...download it and test driver it...than you've some Idea of more questions.
Getting LinuxCNC
I second the advice to download the distro and play around with it.A cheap BOB and a basic stepper might be useful too.There is a forum at https://forum.linuxcnc.org/ . They know a lot about it.
I've tried to install latest LinuxCNC on x86 confuzer, and received a message that 32 bit platform is unsupported
So, x86 is a NoGo, unless you install a bit older version.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
Thanks for the direction.