There have been several threads here on the Zone about designing an atc spindle, and there have been a couple about the building an atc spindle. I can say without a doubt that this thread has more useable information than any.
I personally want to thank Henrik for the thread and the willingness to share, and Daza for sharing some of the knowledge he has accumulated over the years. This type thread is what I like most about CNCZone.
Now the question. What is the estimated cost of something like this, assuming one has the machines to make the part but less the grinding? What additional cost would be added to take the spindle speed to 20,000rpm?
Mike
No greater love can a man have than this, that he give his life for a friend.