Originally Posted by
big_mak
If you want to get to the floor quick, I'd recommend OneCNC. It is damned fast to get programs out to the floor. And you can get it for less than half of mastercam!(nuts)
And you get less than half of Mastercam.
BTW, Mastercam can go from print to part pretty damn fast just using menus, but throw in some scripts and libraries and I'm thinking it can compete with just about any other package.
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)