I am nesting various components in BSolid, then cutting them in one milling operation. Is there a way to choose the order which the components are cut, from within the milling operation?
I have the same issue if I nest using BNest - basically I want to work from bottom->top and left->right in my cutting order when cutting smaller components which don't hold down so well on the vacuum table. (I don't want to leave tabs, as this messes with the edge-finish on acrylic).
our old 'V-Carve' software let us choose the sequence in which the nested pieces would cut when setting up the milling toolpath, but I can't find anything like this in BSolid.