[Jonathon]

Hey everyone, This is my first of many post's, just found the site.

Anyway,
I have two Hercus machines with "ANCA 2000"controllers, one is a Compulathe and the other a Compumill. I have the manuals but they don't decribe anything about using the DNC function, I would really like to get this working as the machines can only hold 24000 characters.
Anyone with any info on these machines would be greatly appreciated.

Jonathon.:rainfro:

[Al_The_Man]

It looks like the company is still around, have you tried emailing them? That would be my first shot.
Al

edit- If you do not have any success I would try a standard RS-232 Null-modem cable, if the machine is set for hardware handshake then this may work, otherwise try the same cable and implement software handshake on the PC end.

[Jonathon]

That was a quick reply, Its 1:16AM here.

I have sent emails to them and they offered to fit a new controller for a huge sum of money, I'm using a null modem cable and hyper terminal at the moment to send files to the machine and this works fine.
The problem is when I select DNC on the machine it just goes back a menu and doesn't respond to any commands, I suppose it could have been an option when new and these machines have the menu item but it's not operational??

[Al_The_Man]

That is probabally like Fanuc, all the options are present but they send a technican out to turn on 1 bit in the parameters and charge $1000~$3000 for the pleasure.
Al

[BPRacing]

Hey everyone, This is my first of many post's, just found the site.

Anyway,
I have two Hercus machines with "ANCA 2000"controllers, one is a Compulathe and the other a Compumill. I have the manuals but they don't decribe anything about using the DNC function, I would really like to get this working as the machines can only hold 24000 characters.
Anyone with any info on these machines would be greatly appreciated.

Jonathon.:rainfro:

Hello Jonathon

I have recently obtained a Hercus Computlathe Model 2000LVL1 which in in need for some restoration and rapairs. I found this forum/site after some key word searches on google. I would like very much to get this machine up and running. I am looking for any manuals or schematics or info to get me started with this project . Please contact me on [email protected]

Regards Matt