I have Fanuc 15MB 9000 parameter editing issue. The machine is Okuma Howa Millac-852 VPF 120 inch 5-Axis.
The problem I have is entering the the three static pw's that allow editing the Hexadecimal values. The procedure I
was told is:
1) Hold "-" and "+" while Pushing Start Button.
2) @ IPL enter "99"
3) No. Axis?
4) Enter 6
5) Enter Static Pass Codes
a)236.....etc.
b)372.....etc.
c)192.....etc.
6) @ Option (01) prompt enter Hex Value for 9100 Binary No,....9101, 91002, Etc.

However, there is no opportunity to enter the 3 Passcodes (Step 5), because the Control immediately
goes to Step 6 and wants the 9000 Hex Values starting at Option (01) and then (02), (03), etc.
Either I am doing this wrong or missing a step. Please if anyone has insight to my problem I would very much appreciate it. Thank you, GBV