IvcarvePro 8.5
I have some line drawing I have made freehand, and I would like to use VCP to import them and using a felt tip marker on the CNC draw them on paper.

Currently the only way I know how to do that is to take a photo of the hand drawings and import it into VCP as a JPG file then select the Vcarve utility and generate Goode which I can then use the CNC to draw the shapes, the problem is that Vcarve generated two lines for Vcarve Ng the center out.

In the attachment below the original hand drawing is in the center, and a smaller CNC drawing is on the left and the two lines almost disappear because of the width of the felt tip I’m using in the CNC, if I enlarge the image as shown by the right side example the two lines are clearly visible.

Is there a way to have VCP draw just a single line so I could enlarge the hand drawings on the CNC.

Thanks
Hager