Thanks to all yes have some ideas
Thanks to all yes have some ideas
25mm linear rails are overkill (by a large margin) for a DIY router. 20mm are more than big enough, and probably cost a bit less. These can carry thousands of pounds per bearing block.So was in my mind thinking 25 to 30 mm dia ballscrew and probably 25mm linear rails
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)