Dear all,
I have a punch machine with Fanuc 0-P controller.
After replace battery without power on, i have to clear memory to start machine.
But it is strange, i only receive 2 error: 417 and 427 for X,Y digital parameter without error 100: Parameter write enable.
So that, i turned on E-stop(ESP) switch, the screen still show "NOT READY" instead of "EMERGENCY" so i can't input Parameter enable =1 on Setting Handy page.
And its strange, i turn on or turn off E-stop switch, bit 701.5 DGN still =1.
And on the master PCB, SO led red and SI led green light.
Anyone know this problem and can you help me?
Thank for your reading and best regard.