586,075 active members*
4,360 visitors online*
Register for free
Login

Thread: bridgeport torq cut 30 shot pin

Results 1 to 3 of 3
  1. 08-07-2007, 11:03 PM #1
    porkchop21
    porkchop21 is offline Registered
    Join Date
    Jan 2007
    Posts
    14

    bridgeport torq cut 30 shot pin

    i need help resetting the shot pin

    i sent my tranny out for a rebuild and now i need to reset the shot pin
    does anyone have instructions or a manual page that i could look at online or both
    it is in a bridgeport torq cut 30 vmc with a dx32 controller

    thanks in advance
    Reply With Quote Reply With Quote
  2. 08-08-2007, 02:00 AM #2
    machintek
    machintek is offline Moderator
    Join Date
    Nov 2004
    Posts
    3028
    The shot pin sits on the bottom of the transmission and locks it in either high or low gear. It is spring loaded and air switched by a solenoid retracts it for shifting. It has a switch to indicate its state to the control.
    Since there is nothing to set, I do not understand your question.

    George
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 08-08-2007, 05:21 PM #3
    porkchop21
    porkchop21 is offline Registered
    Join Date
    Jan 2007
    Posts
    14
    im sorry it wasnt the shot pin it was the trans sw switch that neede to be reset and adjusted i have it all done back up and running

    thanks
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. DX32 questions (Bridgeport Torq Cut 22, DX-32, DX 32)
    By vettespeed in forum Bridgeport / Hardinge Mills
    Replies: 13
    Last Post: 04-21-2016, 07:54 AM
  2. Info on Bridgeport Torq Cut 22 w/ DX 32 or other small machines??
    By vettespeed in forum Knee Vertical Mills
    Replies: 17
    Last Post: 10-04-2010, 11:19 PM
  3. Bridgeport DX-32 Torq-cut 22 peck drill problems
    By RedGTZ in forum Bridgeport / Hardinge Mills
    Replies: 5
    Last Post: 02-02-2007, 06:47 AM
  4. Bridgeport Torq-Cut 2G-?????
    By bherr in forum Bridgeport / Hardinge Mills
    Replies: 17
    Last Post: 10-21-2006, 06:56 AM
  5. Bridgeport Torq Cut 22: What lubricants? Where? How?
    By vettespeed in forum Bridgeport / Hardinge Mills
    Replies: 5
    Last Post: 06-24-2006, 07:38 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules