Re: Tool setter wiring help UB1
Originally Posted by
ChrisAttebery
There are two switches in parallel. One is for the offset, the other is for over travel. I don’t remember which colors are which though. You should be able to decipher the instructions with that in mind.
Switches are not in parallel. There are two independent switches.
Use a multimeter to find wire pairs that belong to each switch. Press a tool setter to activate both switches and find which wires are shorted.
Next step is to apply a pressure just to activate the first switch (for tool height setting) and determine the pair that is shorted. Second pair would be connected to E-stop circuit.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.