Originally Posted by
rwskinner
I was doing a job today running real easy, then the machine shutdown with C Axis Fault - Motor Overload.
No other error codes. If I reset it, and try again, I might get about 5 Inverter Faults on the screen, or it runs a few seconds then trips the again on motor overload.
INV-0054 Baldor Drive - No Rigid tapping and no encoder.
No faults on the Baldor inverter.
If I put the Baldor in Local, it runs fine from the keypad. It's almost like the fadal getting a false signal.
Any ideas where to check?