Folks,
I have searched the internet for this information but have come up short each time. Sorry if I missed the proper key words!
I have an AXBB-E and I am attempting to use it with the UCCNC controller software. Currently everything is running fine but I have followed the instructions from the drivers (CL86Y, StepperOnline) and the controller. I haven't found an answer to is whether I should use isolated outputs or non-isolated outputs for the PU and DR wiring. My plan is to use this for routing and plasma cutting, thus my reason for thinking I want to use isolated ports. While all the documentation shows I should use non-isolated ports, they aren't specific to a plasma system and closed loop system. Would using isolated ports help with high frequency feedback from the Plasma Cutter?
At this time my Z-Axis is not closed loop and I don't see the need to use isolated ports because I don't have a Torch Height Control module and it will only be used when routing.
I asked the vendor I bought the controller from and they suggested I buy an upgraded controller but they also stated it was possible to use what I bought but it would involve much more wiring and that I needed to get the details from StepperOnline. StepperOnline sent me the manual that came with the drivers.
Thoughts?
Regards,
Greg