Originally Posted by
efm194
Hello freakycnc, thank you very much for your answer, I have turned the thumbwheel in all positions and it does not let me see anything, it may be because the former owner made an update to use connection ports and thus deactivate the tape because the tape It is empty and I remembered that the old owner told me that the software had updated it. Maybe that range is deactivated because it was relative to the tape?
Right now I am at a point where the servos move but it does not let me put in zero position because the axis does not stop and it ends up pressing the soft emergency stop and I follow the procedure to the letter, first I press the switch zero positon then I move the z axis away from the atc position several inches and I give the + button and the z axis goes up but it does not stop when it reaches home position it does not even decelerate and ends up skipping the soft emergency which is the one that I can reset easily With the reset button, I am already confused I do not know if it is something of parameters or some failure of a pcb. In the spindle pcb cabinet where the LEDs have the SOURCE, ZSP, NDET, TDET LEDs lit, the latter sometimes lights up, other times not, these LEDs are normal?
Thanks in advance.