My 1997 Arrow 500 is shutting down with an Alarm saying, Axis 'Drive ready' signal missing.
Cause: The axis drive signal has been lost.
Input cr_axes_rdy (100:00/32 is off)
All the drives come on normally all green led lights, until I hit cycle start. It loads the tool the spindle spins up, z axis moves a couple inches, then it's as if somebody hit the e-stop. Everything stops and I get the alarm message.
Anybody got a feel for what may be the cause of this.
Could a bad servo cable or servo cable connection do this.
Could a bad psr module do this.
I've got run of parts hung up because of this, help would be greatly appreciated.