Good day.
I entered parameters into 10T except “pitch error compensation data”. After turning power on message appears “OT002 C –OVERTRAVEL (SOFT 1)”. I can reset that alarm executing actions described in manual: turn on power while pressing “-” and “.” keys and so on. But after next turning machine on, that message appears again. How solve this problem? May be it connected with absence of “pitch error compensation data”? And where I can get these parameters?
Best regards, Viktor
Results 1 to 2 of 2
-
08-13-2007, 10:55 AM #1
Member
- Join Date
- Aug 2007
- Posts
- 793
error “OT002 C –OVERTRAVEL (SOFT 1)”; 10T
-
08-13-2007, 02:56 PM #2
Registered
- Join Date
- Apr 2007
- Posts
- 128
It is `C` Axis over Travel Alarm. In your Machine are you having the C axis if you are having Check the soft ware limits of C axis, otherwise you have to disable C Axis. This is not related to the Pitch error compensation.
Reply With QuoteSimilar Threads
-
Keep getting z axis overtravel alarm 146
By dragon864 in forum Haas MillsReplies: 3Last Post: 07-21-2007, 12:13 AM -
Help with Z overtravel
By mbam in forum FadalReplies: 6Last Post: 04-27-2007, 06:12 PM -
shoda router overtravel on all axis
By stanman in forum Commercial CNC Wood RoutersReplies: 6Last Post: 11-02-2006, 12:26 AM -
hard overtravel on all axis
By stanman in forum Commercial CNC Wood RoutersReplies: 1Last Post: 10-31-2006, 11:07 PM -
+/- Overtravel error for all axis
By claucampan in forum FanucReplies: 2Last Post: 08-09-2006, 12:11 AM
Posting Permissions
