so long story short, I was given 8 of these servo motors and drivers and I don't know the first thing about DC servo motors, but I find myself in a situation where I could possibly use a few of them. I could use some help figuring out what voltage these motors should be run at as they are not marked on the face plate. I also don't understand why a DC servo would have 4 wires that all go to brushes, so any insight would be appreciated. I've looked the internet up and down and can't seem to find a spec sheet anywhere for this part number (Inductive Components PN IC-10166-1)
I found the manual for the Copley Drive (303-1) after a long internet search so I have the pin outs, although I have no idea what the little daughter card connected to it does. The power input and motor output signal is wired directly to it.
Attachment 463066
Attachment 463068