543,874 active members*
2,468 visitors online*
Register for free
Login
Results 1 to 4 of 4
  1. #1
    Registered
    Join Date
    Dec 2007
    Posts
    341

    Need Flywheel turned 11"

    Need to have a fly wheel turned on outside diameter and rim edges two ( ea. ) # 60 surface finish, fly wheel approximate 11 inches casting ,bore HOLE FOR SLIDING FIT FOR .625 SHAFT also put in 1/4 20 setscrew hole for grub screw 15 degree angle thread not necessary.
    The set screw will be centered on the hub either side does not matter , all sizes are as they just clean up to remove casting flash ,clean up center hub, face both end's no clean up on the diameters of center hub.

  2. #2
    Member
    Join Date
    Apr 2020
    Posts
    29

    Re: Need Flywheel turned 11"

    Hi there, do you have 2D and 3D drawings for this? To quote, I need the detailed drawings.

  3. #3
    Registered
    Join Date
    Dec 2007
    Posts
    341

    Re: Need Flywheel turned 11"

    I have a drawing ,all machined surfaces just to clean up and finish cast iron 60 finish

  4. #4
    Registered
    Join Date
    Dec 2007
    Posts
    341

    Re: Need Flywheel turned 11"

    The job has been filled .
    Thank you for to those who replied

Similar Threads

  1. Need 3" Dia Part Turned
    By BLKFLD in forum RFQ (Request for Quote)
    Replies: 3
    Last Post: 10-08-2018, 03:23 PM
  2. Replies: 2
    Last Post: 07-10-2015, 02:18 PM
  3. Batch of turned stainless parts, 85 pieces from 0.5" rod
    By LokiComponents in forum USA RFQ's
    Replies: 7
    Last Post: 05-26-2015, 12:49 AM
  4. 1.5" Dia Part turned from Steel w/ flats - Qty of 100
    By yantra3d in forum RFQ (Request for Quote)
    Replies: 3
    Last Post: 05-08-2011, 04:47 AM
  5. RFQ: Turned 304 stainless parts... 5/8" max diameter...
    By InspirationTool in forum Employment Opportunity
    Replies: 6
    Last Post: 06-22-2007, 09:43 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •