Hi - a few years ago I bought a used 2013 Torus Pro with Servos. The computer has been crashing a lot lately and may have finally died this week. I have a spare computer with Windows 7 and Mach3(registered to another user) already installed. I tried to hook this computer up today by swapping the Parallel,Serial and all USB ports. When I turned it on, the BOB (Rev 5.1) and the Servos (EP1) did not turn on. I am sure that the new computer will need to be configured to run the motors but I am not sure where to start. I see that Novakon has a few downloads on their website that may be of help here... "Torus Pro with BOB Rev5.x" but when I click them I get a page of gibberish. Any advise here? is there a way to get the necessary files/ settings from another person with a similar machine?