Hi Guys,

Second issue on my PCNC 1100.

When I try to reference my ATC , it rotates once and when the magnet is on the reed switch it starts to shake like it is not registering the sensor.
Sometimes this will go on for seconds, other times minutes before I get the error that says "ATC I/O failure"

My USB cable was damaged so I replaced it. (It arced through to the main body, cable got pinched somewhere)

I rebooted. Made sure the sensor is clean of any debris.

Would you recommend I update PathPilot because the software on my PC is old.

Any other areas I can investigate?

Cheers
Juan