Hey everybody,

I'm new here, and to CNC machining in general, and I'm seeking advice for work holding setups for my Taig.

The parts I'm cutting are simple small injection molds in 6061 aluminum bar (will upgrade to better alloys after testing the molds), typically around 3" deep x 8" wide and usually about 1" thick. I started with a 3" screwless toolmakers vise, but quickly realized that the height of the vise interferes with my Z axis leadscrew, resulting in very limited travel. I searched around for some t-slot side clamps to try to hold the work down directly on the table, but the small t-slots on the Taig make it difficult to find pre-made solutions. I also tried some of these shop fox cam clamps, but worry they're going to shake lose over time.

https://www.amazon.com/Shop-Fox-D334.../dp/B00012XE0A

Just wanted to reach out and see if there is a solution out there I overlooked. Another option would be to oversize the stock and bolt it directly to the table.

Thanks for your help!