Mach3, BOB S25S, G540 Driver

Want to add Hall effect sensors to my CNC for homing and limit switches. The ones I have can be analog or digital, pretty sure I want a digital signal.

I was looking at YT for wiring layout, found dozens of them but they were all For Arduino boards. They will work with the INPUTS on my BOB won’t they?

Could someone give me the diagram to do this.

Att is a photo of the Sensor and a page from the C25S BOB manual, that might tell an engineer how to hook it up, but it’s Greek to me, I need a simple labeled drawing of how to hook it up.
Thanks
Hager