587,051 active members*
3,761 visitors online*
Register for free
Login

Thread: St-15 v axis alarm

Results 1 to 2 of 2
  1. 07-31-2021, 02:49 AM #1
    timmydabull
    timmydabull is offline Registered
    Join Date
    Jul 2006
    Posts
    297

    St-15 v axis alarm

    2017 ST-15 went to install a 2016 servo 300 barfeeder today,after installing the cables,and changing parameters i get a v axis alarm 832, i cannot clear the alarm or get into the parameters to change them back to factory.

    any suggestions would help

    thank yu in advance.
    2007 Haas TMP-1 Microscribe MX-5 Mastercam X4 Mill Level 3 Surfaces,Solids Seagate 2 tb hard drive AMD 64x2 8gig ram windows ultimate 7 64bit Geoforce 8800 GTX
    Reply With Quote Reply With Quote
  2. 08-01-2021, 11:42 PM #2
    timmydabull
    timmydabull is offline Registered
    Join Date
    Jul 2006
    Posts
    297

    Re: St-15 v axis alarm

    i got it, i did not realize there was amphenol connector underneath and inside the sheetmetal

    connected it and it allowed me to access parameter list

    i am getting a 835 v axis serial data communication alarm i cant figure out but im sure Haas will have an answer for that tomorrow when they open.
    2007 Haas TMP-1 Microscribe MX-5 Mastercam X4 Mill Level 3 Surfaces,Solids Seagate 2 tb hard drive AMD 64x2 8gig ram windows ultimate 7 64bit Geoforce 8800 GTX
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Arrow2 750 - Axis Puls enable alarm & X-Axis drive alarm
    By PensFan1028 in forum Cincinnati CNC
    Replies: 7
    Last Post: 05-25-2020, 02:32 PM
  2. Fanuc 10tf, Axis Torque Alarm, mem Z axis Alarm, already changed Z drive and motor?
    By blakemachine in forum Fanuc
    Replies: 2
    Last Post: 11-24-2018, 09:15 PM
  3. 414 SERVO ALARM: V AXIS DETECTED ERR , and 449 V AXIS: INV.IPM ALARM
    By majstorluk in forum Fanuc
    Replies: 0
    Last Post: 12-22-2017, 11:59 AM
  4. Alarm 414 Servo Alarm : Y axis detect error
    By Ososa in forum Fanuc
    Replies: 1
    Last Post: 04-10-2017, 05:01 AM
  5. 300 APC Alarm : Y Axis need zrn & 306 APC Alarm: Y axis battery zero on Fanuc 16i-LA
    By pacos in forum Fanuc
    Replies: 1
    Last Post: 01-26-2016, 05:36 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules